CONVERT CISCO AP FROM AUTONOMOUS TO LWAPP MODE

CONVERT CISCO AP FROM AUTONOMOUS TO LWAPP MODE

Connect the Device to the Computer

Open wireshark and run

Wait for cdp broadcast

Check the ip address

Give the same IP address for the Laptop

Connect using telnet

Give username “cisco” password “Cisco”

Enable password “Cisco”

Do a sh run and copy the config

Once config copied do a erase flash:

After erasing the flash copy the new image files to the flash using tftp32
In AP : give the command "archive download-sw /force-reload tftp://192.168.1.8/c1240-rcvk9w8-tar.124-25e.JAP1.tar"

or

In AP : give the command “copy tftp: flash:”

Tftp IP Address

File Name

File name in Flash:

Then xtract the tar image file to the flash

Archive tar /xtract c1130-rcvk9w8-tar.124-10b.jda.tar c1130-rcvk9w8-tar.124-10b.jda

Go to the config menu and enable telnet and assign the ip address

Wr and save the config

Check the flash using sh flash command

Reload

Enter the device using telnet

Do a sh flash and and check the firmware


Required tools are available in the following Links below,

http://www.4shared.com/file/louI3vfT/c1130-rcvk9w8-tar124-10bjda.html

http://www.4shared.com/zip/GxkUBtig/tftpd32400.html

http://www.4shared.com/file/XYsIPtLj/c1130-k9w7-tar124-21aJY.html