Configure WLC 5508 for Internal and Guest WLAN
Access the controller Web Console using its Management IP Address (In this case 10.20.0.10)
Below is the Steps to Configure the WLC for two SSID's with two Subnets
(1) Under Controllers Tab --> Internal DHCP Server-->DHCP Scope
(a) TESTZONE SCOPE -- 10.20.0.50 - 10.20.0.55
Default Router ---- 10.20.0.1
(b)GUESTZONE SCOPE -- 10.10.0.50 - 10.10.0.55
Default Router ---- 10.10.0.1
(2) Controller --> Interface
(a) Management - VLAN20
IP Address - 10.20.0.10
Gateway - 10.20.0.1
Primary DHCP - 10.20.0.10
Create a new interface Guest
(b) GuestInt - VLAN10
IP Address - 10.10.0.10
Gateway - 10.10.0.1
Primary DHCP - 10.20.0.10
(3)Controller --> Interface GP
(a) Guest
Interface name : Guest Int
(b) Test
Interface name : Management
(4)WLANS --> Create New --> general
(a) TESTZONE --> Interface : Management
(b) GUEST -->Interface : Guestint
(5)WLANS-->ADVANCED-->APGROUPS
(a) TESTGP-->WLANS
(1) TESTZONE
(2) TESTGUEST
Access the controller Web Console using its Management IP Address (In this case 10.20.0.10)
Below is the Steps to Configure the WLC for two SSID's with two Subnets
(1) Under Controllers Tab --> Internal DHCP Server-->DHCP Scope
(a) TESTZONE SCOPE -- 10.20.0.50 - 10.20.0.55
Default Router ---- 10.20.0.1
(b)GUESTZONE SCOPE -- 10.10.0.50 - 10.10.0.55
Default Router ---- 10.10.0.1
(2) Controller --> Interface
(a) Management - VLAN20
IP Address - 10.20.0.10
Gateway - 10.20.0.1
Primary DHCP - 10.20.0.10
Create a new interface Guest
(b) GuestInt - VLAN10
IP Address - 10.10.0.10
Gateway - 10.10.0.1
Primary DHCP - 10.20.0.10
(3)Controller --> Interface GP
(a) Guest
Interface name : Guest Int
(b) Test
Interface name : Management
(4)WLANS --> Create New --> general
(a) TESTZONE --> Interface : Management
(b) GUEST -->Interface : Guestint
(5)WLANS-->ADVANCED-->APGROUPS
(a) TESTGP-->WLANS
(1) TESTZONE
(2) TESTGUEST
Very good right to the point
ReplyDeleteDo you have anything about join to Active directory
Thanks
Thank you, This what i was looking for
ReplyDelete